Connect Industrial Light Fixtures With Wall Switch
Industrial light fixtures – Wall switches more often to control ceiling lighting fixtures. The ceiling lights can be changed when the remodeling to update the appearance of the rooms are illuminated. They can also be changed when the uses of the rooms demand more intense light, or more subtle light. Ceiling lighting fixtures have been standardized mechanisms that help with their removal and mounting installation.
How to connect industrial light fixtures with a wall switch. Turn off the switch that controls the light. Remove the light cap and the bulb. Loosen the two screws that pass through the base of the light. These screws usually go through slots that have holes in one end large enough for the head of the bolt to be removed. Turn the lamp until the screw heads align with the holes in the ends of the slots. Pull down on the accessory to release it. Disconnect the black and white cables from the circuit of the luminaire cables. .
12 Photos Gallery of: Connect Industrial Light Fixtures With Wall Switch
Connect the ground wire of the new appliance and the ground wire of the circuit to the earth screw of the electrical box. Connect the black circuit cable to the black cable of the luminaire. Twist in a wire plug, and tape the wire nut and wires together. Connect the white circuit cable to the white cable of the device. Then for connect industrial light fixtures with a wall switch. Insert the excess cable into the electrical box and lift the accessory into place. Align bolt heads with round openings in the slots and push the attachment up so the screw heads come through the holes. Turn the bulb holder so that the heads stick under the slots and the device rests on them. Install the bulb and then install the light cover.